1. Home
  2. Security Hardening
  3. CIS VMware ESXi 6.5 V1.0.0 L1
  4. Ensure dvfilter API is not configured if not used

Ensure dvfilter API is not configured if not used

Details

The dvfilter network API is used by some products (e.g., VMSafe). If it is not in use, it

should not be configured to send network information to a VM.

*Rationale*

If the dvfilter network API is enabled in the future and it is already configured, an attacker might attempt to connect

a VM to it, thereby potentially providing access to the network of other VMs on the host.

Solution

To remove the configuration for the dvfilter network API, perform the following from the vSphere web client:

1. Select the host and click “Configure” -> “System” -> “Advanced System Settings”.
2. Enter Net.DVFilterBindIpAddress in the filter.
3. Set Net.DVFilterBindIpAddress to an empty value.
4. If an appliance is being used, make sure the value of this parameter is set to the
proper IP address.
5. Make sure the attribute is highlighted, then click the pencil icon.
6. Enter the proper IP address.
7. Click “OK”.

Supportive Information

The following resource is also helpful.

This security hardening control applies to the following category of controls within NIST 800-53: System and Information Integrity.This control applies to the following type of system VMware.

References

Source

Updated on July 16, 2022
Was this article helpful?

Related Articles