Details

The autorestart parameter specifies if the database instance should restart after an abnormal termination. It is recommended that this parameter be set to ON.

Solution

1. Connect to the DB2 database
db2 => connect to $DB2DATABASE user $USERNAME using $PASSWORD
2. Run the following command from the DB2 command window-
db2 => update database configuration using autorestart on

Supportive Information

The following resource is also helpful.

• https://workbench.cisecurity.org/files/162

This security hardening control applies to the following category of controls within NIST 800-53: Configuration Management.This control applies to the following type of system Windows.

References

• 800-53|CM-6b.
• CSCv6|3.1

Source

• Tenable.com/audits