Details
Reconstruction of harmful events or forensic analysis is not possible if audit records do not contain enough information.
Organizations consider limiting the additional audit information to only that information explicitly needed for specific audit requirements. The additional information required is dependent on the type of information (i.e., sensitivity of the data and the environment within which it resides). At a minimum, the organization must audit full-text recordings of privileged commands. The organization must maintain audit trails in sufficient detail to reconstruct events to determine the cause and impact of compromise.
Solution
Enable logging on the switch with sufficient detail to fulfill the specifications set forth in the VulDiscussion.
To configure logging to a remote syslog server at the informational level, enter:
switch#config
switch(config)#logging host [ip address]
switch(config)#logging trap informational
Then configure the following AAA:
aaa accounting commands all default start-stop logging [group radius]
Supportive Information
The following resource is also helpful.
This security hardening control applies to the following category of controls within NIST 800-53: Audit and Accountability.This control applies to the following type of system Arista.
References
- 800-53|AU-3(1)
- CAT|III
- CCI|CCI-000135
- Group-ID|V-60851
- Rule-ID|SV-75307r1_rule
- STIG-ID|AMLS-NM-000200
- Vuln-ID|V-60851