Details

VLAN 1 must not be used for user VLANs.

In a VLAN-based network, switches use VLAN 1 as the default VLAN for in-band management and to communicate with other networking devices using Spanning-Tree Protocol (STP), Cisco Discovery Protocol (CDP), Dynamic Trunking Protocol (DTP), VLAN Trunking Protocol (VTP), and Port Aggregation Protocol (PAgP)–all untagged traffic. As a consequence, VLAN 1 may unwisely span the entire network if not appropriately pruned. If its scope is large enough, the risk of compromise can increase significantly.

Solution

Best practices for VLAN-based networks is to prune unnecessary ports from gaining access to VLAN 1 as well as the management VLAN, and to separate in-band management, device protocol, and data traffic.

Supportive Information

The following resource is also helpful.

• https://iasecontent.disa.mil/stigs/zip/U_Network_L2_Switch_V8R27_STIG.zip

This security hardening control applies to the following category of controls within NIST 800-53: Access Control.This control applies to the following type of system Cisco.

References

• 800-53|AC-4(21)
• CAT|II
• Rule-ID|SV-3971r2_rule
• STIG-ID|NET-VLAN-004
• Vuln-ID|V-3971

Source

• Tenable.com/audits