Details

If YPCHECK is not set to true in asetenv, then ypfiles may not be checked.

Solution

Edit the ASET configuration and set YPCHECK to true on systems running NIS. (If NIS+ is configured, YPCHECK must only be set to false to avoid going into NIS compatibility mode.) Configure NIS to use YPCHECK.

Supportive Information

The following resource is also helpful.

• https://dl.dod.cyber.mil/wp-content/uploads/stigs/zip/U_SOL_10_x86_V2R2_STIG.ziphttps://dl.dod.cyber.mil/wp-content/uploads/stigs/zip/U_SOL_10_x86_V2R2_STIG.ziphttps://dl.dod.cyber.mil/wp-content/uploads/stigs/zip/U_SOL_10_x86_V2R2_STIG.zip

This security hardening control applies to the following category of controls within NIST 800-53: Access Control, Configuration Management.This control applies to the following type of system Unix.

References

• 800-53|AC-4(8)
• 800-53|CM-6b.
• CAT|II
• CCI|CCI-000032
• CCI|CCI-000366
• CSCv6|3.1
• Rule-ID|SV-220071r603266_rule
• STIG-ID|GEN000000-SOL00200
• STIG-Legacy|SV-36750
• STIG-Legacy|V-954
• Vuln-ID|V-220071

Source

• Tenable.com/audits